Job Details

Instrumentation and Controls (I&C) Design EngineerJob DescriptionProvide essential technical knowledge and perform engineering work as described below. This position serves as a staff engineer performing engineering assignment of intermediate complexity.Under direct supervision of the Discipline Lead Engineer or Area Lead Engineer, analyze and make independent recommendations regarding technical solutions to problems of intermediate complexity in accordance with project requirementsDevelop and review specifications and design criteriaPerform and check engineering analyses and calculations; specify materials, equipment and systems; and solve technical problems of intermediate complexityCoordinate technical issues with other disciplines, project management, vendors and clients Execute work in compliance with Project Quality Plan and proceduresExecute work in accordance with the approved project scope, cost, and schedule baselines Establish, control and report on material key quantities; provide analysis, and forecasts Provide technical support to activities associated with equipment and material procurement and subcontracting including scopes of work, technical bid evaluations, and review of vendor submittalsProvide technical support to activities associated with construction administration including response to construction requests-for-information and field changesOther duties as assignedBasic Job RequirementsU.S. Citizenship requiredBachelor of Science degree in Control Systems Engineering, Electrical Engineering, Chemical Engineering or related engineering field and minimum five (5) years of work-related experienceWorking knowledge of applicable federal (including Department of Energy orders), state, and local codes and standardsAbility to communicate effectively with audiences that include but are not limited to project management, coworkers, clients, vendors, and subcontractorsJob related technical knowledge necessary to complete the job Intermediate knowledge of discipline codes and standardsAbility to perform work in compliance with applicable local, state, and federal codes, statutes and guidelinesAbility to attend to detail and work in a time-conscious and time-effective manner Intermediate computer and software skills to include proficiency in the use of word processing, e-mail, spreadsheet and electronic presentation programsExperience providing Engineering, Procurement, and Construction (EPC) services on commercial or industrial projectsProficiency executing EPC projects utilizing engineering analysis, 3D modeling and 2D Computer-Aided Drafting and Design (CADD) automation tools in a multi-discipline environmentDiscipline Specific Job RequirementsPerform a broad range of I&C design activities, including design definition, control systems architecture and development, digital systems, Programmable Logic Controller (PLC), Distributed Control Systems (DCS), network configuration, logic development, network switches, process controls, Piping and Instrumentation Diagram (P&ID) development support and review, HMI, communication protocols, routing, and layout, Safety Integrity Level (SIL), and procurement activitiesPrepare and modify instrument and control systems design documents (e.g., instrument datasheets, Input / Output wiring diagrams, schematics, panel layouts, logic diagrams, cable schedules, and instrument installation details)Perform control systems sizing calculations for control valves, relief valves, flow elements, thermowells and other instrumentationCreate instrument index and datasheets and generate reports in Intergraph SmartPlant Instrumentation (SPI) databaseDevelop intermediate complexity control systems narrative specifications Develop basic control systems logic diagrams and/or cause and effect diagrams Represent control systems and participate in model reviewsDevelop specifications and design of DCS, PLC and Safety Instrumented Systems (SIS) hardware and software applications; monitor DCS / PLC / SIS design developed by the design groupPreferred QualificationsProfessional Engineer license Practical field experienceEPC project experience for the following industries:U.S Department of Energy or other U.S. Federal Government Agency Nuclear facilities under a nuclear quality assurance program Manufacturing, pharmaceutical or biotechnologyProficiency with Bentley MicroStation Proficiency with Autodesk AutoCAD Proficiency with Intergraph SPI Intermediate knowledge of:Specifying instrumentation Control systems procurement activitiesP&ID representation; can recognize / report problems associated with control systems representation on P&IDDeveloping control strategies and represent on P&ID Instrument design and installation requirements